Sevcon millipak
#SEVCON MILLIPAK FREE#
24-volt default setting.\r\rIf not using seat switch \(Pin 5\), replace switch with jumper wire to B-.\r\rPin 4 should not be connected until after controller is turned on.\r\rController should be mounted to a paint free metal surface with thermal transfer grease.\r\rAccelerator potentiometer should travel from 0 to 5k for Min to Max speed.\r\rFuses are recommended in case of wiring short circuit.) Part Name: 633T45308 DC Controller 48V 500A for MillipaK Sevcon Golf Carts. Pin 4 should not be connected until after controller is turned on.Ĭontroller should be mounted to a paint free metal surface with thermal transfer grease.Īccelerator potentiometer should travel from 0 to 5k for Min to Max speed.įuses are recommended in case of wiring short circuit.) ALL REMANUFACTURED AND REBUILT ITEMS ARE SUBJECT TO A CORE CHARGE. I had someone rebuild the motor and after getting it back. He told me it needed batteries so I replaced the batteries with brand new ones only to find out the front motor was bad. THIS PART IS ALSO LISTED UNDER PART NUMBER : 633T45320. I have a bad boy buggy with a Sevcon Millipak Controller (633T45312) that I just recently had a friend give to me. If not using seat switch \(Pin 5\), replace switch with jumper wire to B-. SEVCON MILLIPAK 24/48V 500A CONTROLLER, 6 MONTHS WARRANTY, UPGRADABLE UP TO 36 MONTH. to perform complete specific fault diagnosis, a Sevcon Controller Customization Utility Handheld Calibrator PN 79001-04, or Computer Interface 79003-04, may be required.